Mares Quad Air Wrist Computer with LED Transmitter

Mares Quad Air Wrist Dive Computer with Transmitter

List Price:$800.00
Our Price :$699.95
Save $100.05!

: Usually Ships in 24 Hours
Product Code: 495123

Description Whats in the Box?
Mares Quad Air integrated Wrist Dive Computer with Transmitter Wrist Big Number Dive Computer has and LED Tank Module that when mounted onto an HP port of the 1'st-stage regulator, its main function is to transmit tank pressure data via hose-less coded RF protocol to the dive computer. The dive computer then displays the tank pressure & calculates gas consumption rate & time remaining before reaching the reserve value. For this to happen, the tank module & the dive computer must be paired. The LED tank module features also, as the name suggests, an LED on the top of the tank module body. The LED can be used on the surface before a dive to distinguish between a full & an empty tank without needing a dive computer to display the exact value. During a dive the LED blinks when certain pressure levels have been reached & can thus alert your dive buddy or dive guide when you have reached the half tank mark or the tank reserve.

The tank module turns on automatically upon pressurization to at least 145 psi (10 bar). It turns off automatically when the pressure drops below 145 psi (10 bar). To save battery power, the tank module turns itself off also when the pressure does not change over more than 4 minutes. This prevents unnecessary battery consumption in case of a pressure check well ahead of a dive with the tank left open afterwards, or in case the tank is not closed, & the first stage purged immediately after a dive, or in the case of stage tanks that are left pressurized during the dive even when not in use. The tank module turns itself on again when a difference of pressure of more than 14.5 psi (1 bar) is sensed.

Upon pressurizing the tank module, if a pressure of 2600 psi (180 bar) or more is sensed, the LED will blink 10 times in Green color in 4-second intervals. The value of 2600 psi (180 bar) can be set by the user via Android app*.

For battery preservation, the LED turns off after the surface check & stays off until a pressure of 1450 psi (100 bar) is reached (half tank warning). At that point it blinks in yellow color once every 4 seconds. Once the tank pressure reaches 725 psi (50 bar) the LED blinks in RED color once every second (tank reserve). The values of 1450 psi (100 bar) & 725 psi (50 bar) can be set by the user via Android app*. The LED can also be activated to blink permanently with Green color for night dives. This is set by the user via Android app*. The Android app* allows the user to perform also the following: - Read the device ID - Read the firmware version - Read the battery voltage - Perform firmware upgrades. Transmitter is powered by a CR123A user-replaceable battery - Battery life: 150-200 dives. Transmitter come's with an owner's manual.

Air Integrated computerized monitoring of tank pressure is used to determine a bottom time which depends not only on your depth, but also on your actual gas consumption, increasing your dive safety. In addition, the gas consumption (referred to the surface) is displayed on the computer for more control over your dive. The computer does this via the HP Transmitter attached to your first stage regulator by sampling the pressure drop over time & giving you the rate of consumption in minutes remaining. If the time remaining is greater than the no-decompression limit for your depth it will display the shorter time allowed. For Download Interface
New 2018 Mare Quad Computer
    • Algorithm: RGBM Mares-Wienke
    • Imperial/Metric Display
    • Memory Capacity: 36 Hours
    • Operating Modes: Air, Nitrox and Free-Dive
    • Fresh/Salt Water Measurements
    • 2 Gases Ranging from 21% to 99% O2
    • Owner's Manual
    • For Download Interface See Mares PC Interface for Dive Link 2
      Mares Air LED Tank Module:
    • Transmit Tank Pressure Data via Hose-Less Coded RF Protocol
    • LED On Top of Tank Module Body
    • LED Functions:
      Surface Mode;
      Distinguish Full/Empty Tank w/o Dive Computer Display Exact Value
      During Dive;
      LED Blinks at Certain Pressure Levels
      Alert Dive Buddy/Guide w/Half Tank or Reserve Reached
    • LED Functions (Colors):
      2600 psi (180 bar) or More, Blink 10 Times in Green Color
      1450 psi (100 bar) 1/2-Tank Warning, Blinks in Yellow
      Green/Yellow Blinks in 4-Second Intervals
      725 psi (50 bar) LED Blinks in RED Color Once Every Second
    • Transmits Cylinder Information to Computer Screen
    • Provides Pressure Display: 0 to 5,000 psi (0 to 350 bars)
    • Eliminates Pressure Gauge Hose
    • Streamlines Your Diving Profile
    • Gives Gas Time Remaining
    • Increased Dive Safety
    • Power User Replaceable CR123 Battery
    • Battery Life: 150-200 Dives

Share your knowledge of this product with other customers... Be the first to write a review

Browse for more products in the same category as this item:

Scuba Gear
Scuba Gear > Accessories
Scuba Gear > Computers & Gauges
Scuba Gear > Computers & Gauges > Wrist Dive Computers