XS Scuba Hookah Hose Hook is secure attachment of a clip without causing potential damage to the hose. Designed for use with all low-pressure scuba hoses with an approximate 0.5" (1.27cm) diameter, the 3.3" (8.4cm) Hose Hook is made from corrosion resistant stainless steel has a 360°-degree swivel arm with threaded locking pin for attachment to hose. The opposite end of the hook has a spring-loaded gate clip opening to attach the hook to your equipment. Also included is a (L x Dia.) 2" x 0.48" (5.1cm x 1.23cm) silicone sleeve that is mounted on the hose for the hooks anchor position.
- XS Scuba Hose Hook:
- Safest Hose Retainer Design Available
- Attachment of Clip or Accessory to Hose Causes Damage:
Too Much Pressure is Exerted on Hose Surface
Damaging Outer and/or Inner Layers, Reducing Hose Strength
Damage to Inner Layer Can Cause Break-Down of Material
Potential of Reduced Flow of Gas - Use-of-Anything-But Hose Hook Void Warranty of Miflex and XS Scuba Hoses
- Secure Attachment of Clip w/o Causing Damage to Hose
- Designed for Use with LP Hoses with Approximate 0.5" (1.27 cm) Diameter
- Construction: Corrosion Resistant Stainless Steel
- 360° Degree Swivel Arm
- Threaded Locking Pin for Attachment to Hose
- Spring Loaded Gate Clip Opening to Attach to Gear
- Includes Silicone Sleeve Anchor Point
- Dimensions: Hook 3.3" (8.4 cm), Sleeve: (L x Dia.) 2" x 0.48" (5.1 cm x 1.23 cm)
- Easy to Install
Often Used for Hookah Rigs
